Simple Home Plumbing And Drain Cleaning
Our plumbing systems are comprised of many elements and mechanisms that all function to keep the plumbing system working correctly and safely. Once in a while a device in the system must be removed to be mended or replaced. One such plumbing device is the drain trap.
A drain trap is a dip in the drain pipe that can be found in floor drains, sinks, toilets…etc. The function of the drain pipe is to constantly remain filled with water in order to prevent sewer gases from leaking into the room which can be toxic if inhaled. Traps must stay in good condition to remain working properly; however, there are instances where a drain trap can become damaged, corroded, clogged with foreign material, or just too old and worn. In these instances, the trap will have to be removed for replacement or repair. Removing a drain pipe is an easy task for a homeowner. If you plan on removing your drain trap, below is a guide on properly removing a trap:
1. To remove a drain trap, you have to first obtain a number of tools. The tools required for the job include: screwdriver, wrench, bucket, and an old towel. It is important to remember that the drain system is delicate therefore you have to be careful when removing the drain trap so that you do not damage it or any other nearby plumbing component.
2. Once you have acquired the necessary tools to remove the drain trap, you should turn off the main water supply or close the water valve under the sink where the water flows through the drain pipe.
3. The step after that is to put the bucket under the sink where the water will flow from the drain trap when you remove it. You may also lay the towels round the bucket in the event of splashing or spillage of water on the floor.
4. The drain pipe is attached to the base of the sink. It is secured with a nut. Use your wrench to get rid of the drain pipe. Employ a wrench and turn the nut to the left to loosen it. After relaxing the nut, pull the pipe straight down to finish the removal.
5. Once the drain pipe is removed, you may then take away the trap. The tail piece will first need to be removed. Then, unscrew the trap. If the drain trap is a swivel kind, the curved trap parts will come out easily. If the drain pipe contains a clean-out plug which you’ll see at the base of the pipe section that curves, use your wrench to take it out. If there isn’t any clean-out plug, you only need to unscrew the slip nut to take out the drain trap. Once you can obtain access to the drain trap, remove it while holding it in the upright position.
The drain pipe is a vital part of the plumbing system that needs to be maintained so it remains in good working order to prevent sewage gas does from escaping. This is very important because sewage gas is harmful and the gas can not always be detected. Regular maintenance of the plumbing systems as well as having annual inspections by a plumber will ensure that components stay in top working condition. If there is a problem with your drain trap or any other part of the plumbing system, it is important to get it fixed right away. For serious problems, it is imperative to contact a professional plumber who will have the equipment and expertise to properly make the repair.
Are you in need of a Boulder City Plumbing or Las Vegas Plumbing for a remodeling project? Have you sprung a leak at home or work? We offer you experienced professional technicians that can fix all types of office and home plumbing requirements.